Lukas traversing system Bedienungsanleitung PDF herunterladen (Seite 13)

The following must always be observed when installing the cylinders:

- non-slip and even ground, so that the entire base area of the cylinder is in contact with

the ground. If there is any doubt as to the load-bearing capacity of the ground, suitable

wooden or metal underplates (blocks) must be used to increase the contact area.

- The area of support must be a continuous level surface (not a grating, gravel etc.)

ATTENTION!

Hydraulic ﬂ uids may produce a lubricating ﬁ lm on the ground!

- Never place cylinders on a yielding underplate

- Never use cylinders without a piston guard plate, in order to avoid damage to the piston

WRONG

RIGHT

WRONG

RIGHT

Load

WRONG RIGHT

Load

share 2

Load proportion 1 = Load proportion 2

Load

share 1

Load

share 1

Load

share 2

Load proportion 1 < Load proportion 2

recommends the use of suitable piston guard plates for this reason, as otherwise there is

a risk of damage to the piston rod or the cylinder. A convex piston guard plate distributes

the load evenly over the piston area again.

If several cylinders/rolling carriages are used simultaneously, the load should be

distributed as evenly as possible over all cylinders/rolling carriages.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Keine Kommentare

Lukas traversing system Bedienungsanleitung Seite 13