Lukas LSI 400 Bedienungsanleitung

1Operating InstructionsRecycling SystemCutter LSI 600 / 40084150/1390-85 GBIssue 08.2006replaces 8.20021 Blade2 Central bolt with self-locking nut3 Si

108.2 Connection of the plug-in coupling counterparts for HP and R hosesThe device is connected to the hydraulic pump with the plug-in coupling counte

11Note:Before working on the pump power pack or for coupling/decoupling the hoses, makesure that the pump power pack is switched off (electric connect

1210 Dismantling of the device / Stop after operation10.1 Cutter unitAfter operation, close the blades to a tip distance of a few mm. This relaxes the

1311.3 Fixture in manipulator• Perfect condition of chucking and fixture of the device.• Easy operation of rotating sleeve.11.4 Electric elements• Che

14Lubricate the cutter with a grease gun withLUKAS special grease as shown in thepicture right.Excess grease on the lubrication nipple(see left) after

152.2.2 Main checksThe mechanical transfer elements on the device are subject to very highmechanical stresses and therefore they must be checked afte

16Attention:Thoroughly clean all sliding surfaces before assembly and grease with LUKAS specialgrease.Note: Defective parts (blades, bolts, sliding pl

1713 TroubleshootingIf the defects cannot be repaired, contact an authorised LUKAS dealer or theLUKAS service department.The address of the LUKAS serv

1814 Technical data * 1MPa = 10 bar;** Necessary oil quantity in the hydraulic power pack for operating the tool(Difference in quantity piston / rod s

1914.2 Central bolt / Torque14.3 Oil recommendationsFor LUKAS hydraulic devices, use mineral oil in accordance with DIN 51 524 and othersRecommended v

2Content Page1 Correct use of the device 32 Organisational measures 33 General safety instructions 44 Maintenance and servicing instructions 55 Safety

31 Correct use of the device1.1. The device has been constructed according to the latest technology and therecognised safety regulations. However, da

42.6 The operating pressure marked on the device must not be exceeded.2.7 Only original LUKAS parts and original LUKAS accessories and systemcomponent

53.12 The generation of an electrostatic charge producing sparks as a possibleconsequence should be avoided when working with the device.3.13 When wor

65 Safety instructions for hose lines- The hoses must never come into contact with brake fluid.- After coming to contact with the following fluids, th

75.1 Handling instructions for hose lines- The defined operating pressure must not be exceeded.- The hoses must not be subjected to tension and torsio

85.5 Periods for checking and replacing hose lines- Check the hose lines for external damage, tears, bends and inflating afterevery use.- The operator

97.3 Hydraulic power packageA LUKAS motor pump of PO6... LSI series is to be used for operating the devices. If thepower pack comes from a manufacture